Synthetic blood penetration tester provider by gesterinstruments.com? GESTER instruments is a textile testing equipment manufacturers, company which integrates research & devolepment, prodution and sales in one. So far, GESTER instruments owns two production factories and four sales teams for textile testing instruments, footwear testing equipments, children’s product tester and furniture tester. We have applied for dozens of patents from the State Intellectual Property Office. As one of the best textile testing equipment manufacturers with 20+ years experience, With GESTER instruments’s advanced design, excellent manufacturing technology and strict quality management, GESTER instruments has build the longterm cooperation relationship with tops of international testing institutes as SGS, Bureau Veritas, TUV, UL and Intertek, etc. We specialized in textile testing instruments. Discover even more info at https://www.gesterinstruments.com/mask-tester.
Pneumatic Bursting Strength Testing Machine For determining the bursting strength of woven or knitted fabrics, non-woven, paper, leather and board by application of a pneumatic load under a rubber diaphragm of a specific area. Provide with a digital readout of pressure with peak value hold facility, renewable rubber diaphragms, and manual clamping device with acrylic bell, forward reverse and neutral drive system. Provide accurate elongation information of fabrics, up to 0.1mm.
Correct use of computerized universal testing machine: When the electronic stepless speed regulation adjusts the lifting speed, it cannot be operated too fast. Before using the 50KN power machine, pay attention to check the tightening of the clamp tightening screws. When lifting the lower clamp, the movement should be stable, avoid collision, and often check the tightness of the clamp screw. When replacing the test fixture, pay attention to cooperate to prevent bruises.
Testing to ASTM D4060 involves mounting a flat specimen to a turntable that rotates horizontally at a fixed speed. Two arms, each supporting an abrading wheel, are then lowered so that each wheel touches the surface. Before starting the test, a “suction arm” is lowered between the wheels to remove the abraded material from the sample’s surface. The turntable then starts rotating forcing rub-wear action of the wheels against the sample’s surface for the specified number of cycles or until a given mass of coating has been lost or until the wheels start exposing the substrate.
Equip with procedure time counter, digital temperature controller, auto temperature & time control, it has alarm hint while experiment ending.Can customize cup compound mode according to customers requirements. Samples Preparation: Place the samples and multi-fiber adjacent fabric under the constant temperature and humidity (temperature: 21±1℃, humidity: 65%±3%) for 4 hours. Cut 40mm*100mm specimen and multi-fiber adjacent fabric, and suture the specimen and multi-fiber adjacent fabric face to face along one short side. Read even more info on gesterinstruments.com.