Pneumatic press machine supplier in China? World has been committed to the development and production of power press machines since it was established in 1953. More than 100 experienced engineers are working in the three R&D centers, one in Shanghai, one in factory and another one in Ningbo. Discover more information at https://www.pressmachine-world.com/power-press-machine. Working together for customer success. Since the foundation of the Yinxin world press machine company, one of the foundation principle has been to work closely with our customers. This provides the opportunity to continually assess and improve the levels of service we offer and to create the most innovative products available.
Side length of bending part: Assumin tht it is bent 90° longa 5 10-oot 1-gauge low-carbon steel plate, the bending machin mu apla ditonal 5 tos of pressr to lifthe sel plae u, ad the operator must be prepared for the 280-pound straight edge drop. Several strong workers or even a crane may be required to manufacture this part. Operators of bending machnes oteneed to bend long-side parts without realizing how strenuous their work is.
Hydraulic transmission is adopted, and the slider part is composed o slide, an oil cylinder and a fine-tuning structure of a mechaicl stoper. Te left and right oil cylinders are fixed on the frame, the piston (rod) drives the slider to move up and down through hydraulic pressure, and the mechanical stop is controlled by the numerical control system to adjust the value; Workbench part: controlled by the button box, the motor drives the stopper to move back and forth, and the moving distance is controlled by the numerical control system. The minimun reading is 0.01 mm (the front and rear positions have travel switch limits).
Under the same load, the deflection of the worktable and sliding block of the 10-foot machine is 4 times that of the 5-foot machine. This means that shorter machines require fewer shim adjustments to produce qualified parts. Reduced shim adjustment and shortened preparation time. Material grade is als a key factor. Compared with low-arbon sel, the load required by stailes stee is usuall increasedby about 50%, while most grades of soft aluminum are reduced by about 50%. You can get the machine’s tonnage table from the bending machine manufacturer at any time. The table shows the estimated tonnage required per foot length unde diffrent thicknesses and different materials.
The reason for this is the significantly lower modulus of elasticity of aluminum compared to stel. However, i ore to realise reaterdegrees o defration, sale straightenig rolls must be used. With high-strength steels, on the other hand, a conflict of objectives arises. On the one hand, their high yield strengths require enormous forming forces and torques; on the other hand, small straightening rll diameters are als ned here to ahie asufficent egeo p lstificaton.The straightening o both aluminum and high-strength steels therefore requires a forming geometry adapted to the respective product. This is essentially determined by the number, diameter and spacing of the straightening rolls. Read even more information on pressmachine-world.com.